The Queue Setup Screen - ZyXEL Communications ZyXEL Prestige P-870HW-51a v2 User Manual

The following table describes the labels in this screen.
Table 37 QoS General
LABEL
Active QoS
Select Default
DSCP Mark
Apply
Cancel

11.4 The Queue Setup Screen

Click QoS > Queue Setup to open the screen as shown next.
Use this screen to configure QoS queue assignment.
Figure 64 QoS Queue Setup
The following table describes the labels in this screen.
Table 38 QoS Queue Setup
LABEL
Add
Queue Key
Active
Name
Interface
Precedence
P-870HW-51a v2 User's Guide
DESCRIPTION
Select the check box to turn on QoS to improve your network
performance.
This field is available only when you select Enable QoS.
If you enable QoS and incoming traffic does not match a class
configured in the Class Setup screen, the ZyXEL Device sets the DSCP
field in the packets with the value you select here. If you select No
Change, the ZyXEL Device keeps the DSCP fields in the packets.
Click Apply to save your changes back to the ZyXEL Device.
Click Cancel to begin configuring this screen afresh.
DESCRIPTION
Click this button to create a new entry.
This is the index number of this entry.
Select the check box to enable the queue.
This shows the descriptive name of this entry.
This shows the name of the ZyXEL Device's interface through which traffic
in this queue passes.
This shows the priority queue of this entry.
Chapter 11 Quality of Service (QoS)
131