Isolator Tie-Down For Unit Sizes 10-30; Isolator Tie-Down Removal For Unit Sizes 66-120; Belt-Drive Plenum Fan Tie-Down; Plug Panel Plate - Trane CSAA Installation, Operation And Maintenance Manual

Installation - Mechanical
Figure 9.

Isolator tie-down for unit sizes 10-30

Required
clearance
Figure 10. Isolator tie-down removal for unit sizes 66-120
Required
clearance
Figure 11. Isolator tie-down removal for unit sizes 35 -
120
Screw (4 per angle)
lockwasher and hex nut
Angle, isolator
tie-down (4 required)
24
Figure 12. Belt-drive plenum fan tie-down
Tiedown
•
Figure 13. Plug panel plate
Tiedown
•
•
•
Note: For outdoor air handlers, after isolator tie-down is
Access for removal of shipping tie-downs for unit sizes
3-30 is available through the fan section access door or
opposite drive-side plug panel. See
Access for removal of shipping tie-downs for unit sizes
3-30 is available through the fan section access door or
opposite drive-side plug panel. See
Remove the bolt. This will release the isolator and
make it possible to remove the pipe or spacer.
Replace plug panel if applicable.
removed, remove the paper backing from the butyl
tape around plug panel perimeter prior to replacing
plug panel.
Required
clearance
Figure 13.
Remove
tie-down
Remove plug panel plate
Figure 13.
CLCH-SVX07K-EN