Section 2. Unit Design - Trane GAF2A0A36M31EC Installer's Manual

Section 2. Unit Design

2.1 Cabinet Penetration
Important: Due to the unique design of this unit,
which allows the electrical wiring to be routed within
the insulation, do not screw, cut, or otherwise puncture
the unit cabinet in any location other than the ones
illustrated.
Important: Under no
strapping be attached to the unit to be used as support
mechanisms for carrying or suspension purposes.
2.2 Panel Removal
The unit contains four (4) access panels: Blower, Coil,
Line Set, and Heater.
The Blower, Coil, Line Set, and Heater panels are
removed using a Phillips head screwdriver.
NOTE: The Blower, Coil and Heater panels must be
removed prior to removing the Line Set panel.
NOTE: The Coil Panel should be removed before the
other panels.
conditions should metal
Screws are allowed up to 3- 3/4"
from the top of the cabinet
(heater compartment).
(Typical both sides)
#3 Size Phillips
3