Controls Interface; Connecting The Operator Display; Calibrating The Operator Display; Service Module - Trane CSAA Installation, Operation And Maintenance Manual

Controls Interface

The portable operator display is used for temporary
connection to and operation of Trane UC600 controller.
With the portable operator display, you can monitor data,
change setpoints, monitor alarms, and override points.
The portable operator display includes a 10 ft (3 m) cable
with connector that is stored in the storage compartment
of the carrying bag. The cable cannot be disconnected
from the operator display. Keep this document with the
portable operator display for access to calibration and
cleaning instructions.
Note: The portable operator display is not used for
timeclock scheduling. To provide scheduling you
must use a Tracer Summit system.
NOTICE
UV Damage!
Avoid damage to display by installing it out of direct
sunlight.

Connecting the Operator Display

To connect the portable operator display:
1. Locate the factory-provided service module (see
Figure 161).
2. Attach the operator-display cable to the operator-
display connector on the service module. The operator
display receives power from the controller and turns
on automatically when it is connected.
Figure 161. Service module
NOTICE
Water Damage!
Spraying water or cleaner directly on the screen could
result in equipment damage. To clean the operator
display, use a cloth dampened with commercial liquid
glass cleaner.
CLCH-SVX07K-EN

Calibrating the Operator Display

This section shows how to calibrate the operator display
touch screen and how to adjust the brightness and
contrast. To set up the operator display screens and
security, see the Tracer TD7 Display for the Tracer UC600
Programmable Controller Installation, Operation, and
Maintenance guide (BAS-SVX50C-EN).
To calibrate the operator display:
1. On the home screen, press Setup. The Setup menu
appears.
2. Page down to view the next screen.
3. Press Calibrate Touch Screen. A calibration screen
appears.
NOTICE
Equipment Damage!
Do not allow the operator display to come in contact
with sharp objects. This could result in equipment
damage.
4. Touch the target using a small, pliable, blunt object,
such as a pencil eraser or your finger. Hold until the
beeping stops. A second calibration screen appears.
5. Again, touch the target with the object. Hold until the
beeping stops. The Advanced Selection screen
appears.
6. Press Home. The home screen appears.
125