Tension The Fan Belt; Belt Tensioner; Tension Drive Belt Label; Belt Tension Measurement - Trane CSAA Installation, Operation And Maintenance Manual

Start-Up

Tension the Fan Belt

NOTICE
Belt Tension!
Excessive belt tension will reduce fan and motor
bearing life, accelerate belt wear and possibly cause
shaft failure. Do not over-tension belts. Under
tensioning belts is the primary cause of premature belt
failure. Belts should not squeal at startup. Recheck belt
tension after 8 hours, 24 hours, and 100 hours of
operation and monthly thereafter.
Proper belt tension is required to ensure maximum
bearing and drive component life and is based on motor
horsepower requirement. A label located on the bearing
support on the drive side of the unit lists all drive parts, the
proper belt tension, and deflection for that tension for the
specific drive (Figure 162).
If the drive is changed from the original, proper belt
tension can be estimated using
The correct operation tension for a V-belt drive is the
lowest tension at which the belts will not slip under the
peak load conditions. It may be necessary, however, to
increase the tension of some drives to reduce excessive
belt flopping or to reduce excessive startup squealing.
Figure 162. Tension drive belt label
V-BELT DRIVE KIT
PURCHASE ORD. NUMBER B24597-061 H5D073B A
CUSTOMER'S KIT # H5D073B A-012-0400
MTR HP.= 10.0
FAN RPM = 1458 CD = 9.4 AT 3.00 TRN OPN
TENSION INFO - 3.86 LB., 0.14 IN.
DRIVE'S BELTS - B40
MOTOR SHEAVE - 2VP75X 1 3/8
MOTOR BUSHING - NONE REQUIRED
FAN SHEAVE - 2B5V80
FAN BUSHING - B 1 7/16
Check the fan belt tension at least three times during the
first days of operation because there is a rapid decrease in
tension until the belt settles in. To measure belt tension,
use a belt tensiometer (see
deflection by depressing one belt with the belt
tensiometer and measuring the deflection relative to the
other belts or to belt line (see
tension to the correct pounds force and tighten all bolts to
the proper torque. See Table 53, p.
130
Table 40.
1627373
MODULE 0400
Figure 163). Determine actual
Figure 164). Adjust the belt
161.
Figure 163. Belt tensioner
Small O-ring
Large O-ring
Figure 164. Belt tension measurement
Belt span
Deflection =
64
Force scale
Span scale
Belt span
CLCH-SVX07K-EN