Factory Training - Trane CSAA Installation, Operation And Maintenance Manual

WARNING
Follow EHS Policies!
Failure to follow instructions below could result in
death or serious injury.
• All Ingersoll Rand personnel must follow Ingersoll
Rand Environmental, Health and Safety (EHS)
policies when performing work such as hot work,
electrical, fall protection, lockout/tagout, refrigerant
handling, etc. All policies can be found on the
site. Where local regulations are more stringent than
these policies, those regulations supersede these
policies.
• Non-Ingersoll Rand personnel should always follow
local regulations.
Copyright
This document and the information in it are the property of
Trane, and may not be used or reproduced in whole or in
part without written permission. Trane reserves the right
to revise this publication at any time, and to make changes
to its content without obligation to notify any person of
such revision or change.
Trademarks
All trademarks referenced in this document are the
trademarks of their respective owners.

Factory Training

Factory training is available through Trane University™ to
help you learn more about the operation and maintenance
of your equipment. To learn about available training
opportunities contact Trane University™.
Online: www.trane.com/traneuniversity
Phone: 855-803-3563
Email: traneuniversity@trane.com
Revision History
• Updated the service clearance for control box's figure
and table in dimensions and weights chapter.
• Replaced the existing photo for shipping tie down
removal with new photo and additional photo for tie
down in installation - mechanical chapter.
• Added new section, DDP fan thrust bumper in
installation - mechanical chapter.
• Updated the transducer image in the start-up chapter.
• Updated miscellaneous changes across the document.
CLCH-SVX07K-EN
BOS
Introduction
3