“2: Protocol Type”: Setting The Communication Protocol Type - Denso BHT-1505B User Manual

 "2: PROTOCOL TYPE": Setting the communication protocol type
2.
Select "2: PROTOCOL TYPE" at the SET COMMUNICATION menu
and then press the ENT key.
The PROTOCOL TYPE menu screen on the right is displayed.
The highlighted setting is the current setting.
"1: Ymodem":
Selects Ymodem when uploading/downloading in System Mode or for
the execution of the XFILE statement in BHT-BASIC.
"2: BHT Protocol":
Selects the BHT-protocol when uploading/downloading in System Mode
or for the execution of the XFILE statement in BHT-BASIC.
"3: BHT-Ir Protocol":
Selects the BHT-Ir protocol when uploading/downloading in System
Mode or for the execution of the XFILE statement in BHT-BASIC.
To make changes, use the cursor keys ([▲] [▼]) or numerical keys ([1] [2] [3]) to highlight the setting item,
and then press the ENT key.
To use the BHT-BASIC 4.0 Transfer Utility, select Ymodem or BHT-Ir protocol.
Press and hold the BS/C key to return to the SET COMMUNICATION menu.
Select "1: Ymodem" at the PROTOCOL TYPE menu to display the screen on the right.
The highlighted setting is the current setting.
"1: CR/LF":
Specifies line delimiters.
"2: CR/LF CODE":
Specifies handling for line delimiters in records when data files are
downloaded.
"Control code":
Does not handle line-break codes as data.
(Handles as record delimiters.)
"Data":
Handles line-break codes as data.
"3: BHT ID":
Specifies whether or not to add the BHT ID number to packets when performing YMODEM transfer.
"None" should normally be selected. To add the BHT ID number to the transfer tool, select "Add". (This
setting is not supported. Changing this setting has no result.)
"4: INTERVAL":
Specifies the retry interval within a range of 1 to 255 in units of 100 ms.
BARCODE Handy Terminal
1 : C R / L F
C R - L F L F C R N o n e
2 : C R / L F C O D E
C o n t r e o l c o d e D a t a
3 : B H T I D
N o n e A d d
4 : I N T E R V A L
5 : C O M P R E S S U P L O A D
N o n e Z I P
[ ]
97