Denso BHT-1505B User Manual page 34

BHT-1500B Series
2.
Then, "Testing" appears.
The screen on the right appears.
In some cases, it may take 20 to 30 seconds for the screen to appear. When complete, the system starts.
If Scandisk finds a broken file or files, the screen on the right appears.
(If any broken files exist, the screen on the right appears each time the BHT starts.)
(Refer to "About "$$BRKLST.SYS" on the following page.)
After a few seconds with the screen displayed, the system starts.
Scandisk when the resume function is enabled
If Scandisk runs when the resume function is enabled, the screen given
right may appear.
(The screen may also appear when the calendar clock built in the BHT stops, even without running
Scandisk.)
− Note −
The resume function is used to return the display to the status (screen) when the power was last
turned OFF when the power is next turned ON.
Resume function settings are made at the "SET SYSTEM" menu. Refer to "Chapter 4 System
Operation" – "4.5.6 System Environment Settings (SET SYSTEM Menu)" for further details.
22
Testing