Denso BHT-1505B User Manual page 218

BHT-1500B Series
Message
206
BHT Response
If this error occurs, the
warning tone beeps five
times.
If this error occurs, the
warning tone beeps five
times.
The message is continuously
displayed.
If this error occurs, the
warning tone beeps five
times and then turns itself
off.
Cause
During execution of
System Program, the
System Program has
attempted to write onto
the write-protected area
of the memory.
(xxxxxxxx: Error address)
During execution of
System Program, the
System Program has
received an invalid
command code.
(xxxxxxxx: Error address)
No user programs are
found when the BHT is
turned on.
Any of the hardware
error, memory error,
execution program error,
etc. has occurred.
(XXXX: Error code)
Countermeasure
Unload and reload the
battery cartridge, then turn
the BHT on.
If this error occurs
frequently, make a note of
the displayed message and
codes and contact your
system administrator.
Unload and reload the
battery cartridge, then turn
the BHT on.
If this error occurs
frequently, make a note of
the displayed message and
codes and contact your
system administrator.
Contact your system
administrator.
You can run the code
scanning demo without user
programs.
Pressing "1:Yes" runs the
code scanning demo.
Press the trigger switch to
start the code scanning
demo. Selecting "2:No" turns
the power off.
Turn the BHT on again. If
this error occurs frequently,
make a note of the displayed
code and contact your
system administrator.