Siemens Add 7 AddFEM Manual page 6

Preface
Add 7 Product Family
The Add 7 product family provides add–on products which allow the inexpensive
realization of high or specific requirements from process control and automation
technology. These products are based on many years of experience in process
control technology as well as extensive knowledge of the current system genera-
tion 7 in the Siemens automation program "Totally Integrated Automation".
As a member of the Add 7 product family, the AddFEM front end module is desi-
gned specifically for the special task of controlling turbines rapidly (different signal
types, redundancy, rapid detection and preprocessing, etc.).
Extensions
6DL3100–8AB provides the possibility to use the AddFEM redundantly (module
redundancy) and/or to edit preprocessing functions on the AddFEM.With
6DL3100–8AC it is possible to parameterize the AddFEM during current operation
with DPV1 services.
Further Support
Should you have any questions on the products described which are not answered
in this documentation, please contact your local Siemens partner.
CE Approval
Our products fulfill the requirements of the EU guideline 89/336/EEC "Electroma-
gnetic Compatibility" and the EU guideline 73/23/EEC "Low voltage guideline" as
well as the harmonized European standards (EN) listed in these guidelines.
In accordance with the above–mentioned EU guidelines the EU declaration of con-
formity are held available for the responsible authorities at:
Siemens Aktiengesellschaft
Automation and Drive Technology Division
A&D SE S21
Siemensallee 84
D–76187 Karlsruhe
AddFEM
C79000–G8076–C900–03
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
i