Selecting An Output Device (Select Output Device) - Canon iR3245 Manual

Selecting an Output Device (Select Output Device)

For instructions on this procedure using the Regular Copy Basic Features screen, see "Selecting an
Output Device (Select Output Device)(p.1-16)."
Remark
If you specify the Form Composition mode with the
Cascade Copy mode, it is necessary to assign the
same name to the stored image form in both this
machine and the remote copy printer beforehand. If the
assigned image form name in this machine is not set in
the remote copy printer, the job is cancelled.If multiple
image forms with the same assigned name are stored
in the remote copy printer, different images may be
used for Form Composition.
7
If you turn the remote copy printer back ON or reattach
the finisher, you need to refresh the settings of the
remote copy printer in Register Remote Device in Copy
Settings (from the Additional Functions screen). (See
"Confirming a Remote Device(p.8-23).")
1. Press [Others] → [Select Device to Output].
2. Select the output device.
If you want to perform Cascade Copy:
●
7-110 Selecting an Output Device (Select Output Device)
If <Use IPv4> in [IPv4 Settings] in [TCP/IP Settings] in
Network Settings in System Settings (from the
Additional Functions screen) is set to 'Off', you cannot
register a remote copy printer. (See the Network
Guide.)
If you connect the machine directly to other remote
copy printers using a crossover patch cord, you must
configure the Ethernet driver as shown below. (See the
Network Guide.)
Auto Detect: Off
Communication Mode: Full Duplex
Ethernet Type: 100 Base-TX