Canon iR3245 Manual page 572

For instructions on specifying copy settings and their available combinations, see
"Combination of Functions Chart(p.9-2)."
3. For each batch of originals, specify the copy settings → press
For instructions on specifying copy settings and their available combinations, see
"Combination of Functions Chart(p.9-2)."
If you are scanning two or more batches of originals, press [Recall Last Setting] to return to
the copy settings for the previous batch.
4. Check the settings on the Scan screen.
You can change or specify the 2-Sided Original, Original Type or Copy Exposure mode
7
before scanning the next batch of originals (i.e., between batches).
If you want to continue to scan another batch of originals without changing the copy settings,
place your originals and press
If you want to rescan or cancel the current batch of originals, press [Clear/Re-enter This
Block] and repeat the procedure from step 3.
If you want to change the copy modes and scan another batch of originals, press [Next
Block] and repeat the procedure from step 3.
5. When you have finished scanning all of your originals, press [Conf./
Combine All Blocks].
You can also press [Conf.Blocks] in step 3 to proceed to step 6.
6. Combine the Batches of documents.
To check the copy settings for the combined document, press [Set. Conf. (Overall)].
To select all of the batches of originals, press [Select All]. However, if a batch of originals is
already selected, this key changes to [Clear Selection].
To add another batch, press [Add Block] and repeat the procedure from step 3.
7-104 Combining Multiple Batches of Originals with Different Copy Settings (Job Block Combination)
.
.