Job Build - Canon iR3245 Manual

Job Build

This mode enables you to scan originals that are too many to be placed at once, by dividing them into
multiple batches. You can use both the feeder and the platen glass for scanning. When copying, the
originals are printed as one document after all of the batches have been scanned.
Remark
The 2-Sided Original mode is available only if the
optional Feeder (DADF-U1) is attached
(standard-equipped for the iR3245N/iR3235N/
iR3225N).
For information on the modes which cannot be set in
combination with this mode, see "Combination of
Functions Chart(p.9-2)."
You cannot change the copy settings while the
machine is scanning originals in the Job Build mode.
You need to set the necessary copy/scan settings
beforehand, according to the type of originals or the
desired result.
If you place your originals in the feeder, remove the
originals from the original output area when the
scanning of each batch is complete.
When copying, you can change or specify the following
settings before scanning the next batch of originals
(i.e., between batches): the number of copies, 2-Sided
Original mode, original type, and copy exposure.
However, if you specify the Image Combination mode
together with the Job Build mode, you cannot change
the copy exposure and original type.
If you use the Job Block Combination mode, the Job
Build mode is automatically set for each batch of
originals. You cannot use the Job Build mode for the
combined document.
If you place different size originals in the feeder, set
the Different Size Originals mode. (See "Different Size
Originals(p.4-42).")
When copying, if you want to copy one-sided and
two-sided originals as two-sided copies, divide the
originals into one-sided and two-sided batches. For
example, if the first batch of originals to be copied
consists of two-sided originals, set the 2-Sided Original
mode accordingly. Thereafter, you have to manually
set or cancel the 2-Sided Original mode for each batch
of originals that you scan.
4
Job Build 4-43