Huawei NE40E Hardware Description page 257

NE40E
Hardware Description
Panel
Table 1-183 Buttons
Name
RST
Table 1-184 Indicators
Name
RUN (green)
ALM (red)
ACT (green)
Optical interface
L/A
MGMT-ETH
LINK (green)
MGMT-ETH ACT
(yellow)
Table 1-185 Management interfaces
Interface
Name
FSP0,
FSP1
GE/10GE
MGMT-E
TH
Issue 01 (2018-05-03)
Description
When this button is pressed, the board is reset.
Description
Before the board is powered on and registers, this indicator status
changes in the following sequence: off > blinks quickly > steady
on > blinks quickly > steady on > blinks slowly (0.5 Hz).
After the board is powered on and registers, if this indicator blinks at
0.5 Hz, the system is working properly.
If this indicator is steady on, an alarm is generated.
If this indicator is off, no alarm is generated.
If this indicator is steady on, the board functions as the master one.
If this indicator is off, the board functions as the slave one.
Reserved.
If this indicator is steady on, the link is Up.
If this indicator is off, the link is Down.
If this indicator is blinking, data is being transmitted and received.
If this indicator is off, no data is being transmitted or received.
Interfac Connec
e Type tor
Type
Serial RJ45
interface
GE/10GE SFP+/S
FP
Ethernet
RJ45
interface
Description Cable
Reserved. It -
functions as an
interface for
fast chassis
switchovers.
Reserved -
cascading
interface.
It connects to Super category 5 shielded twisted
an NMS and pair
1 Hardware Description
243