Huawei NE40E Hardware Description page 169

NE40E
Hardware Description
Powe
r
Supp
ly
Area
B
Power Supply Principles
PEMs are integrated into the chassis and do not need to be configured onsite. Do not remove
and install PEMs onsite. PMs can be configured based on the overall power consumption of
the device to flexibly supply power.

Table 1-76 Power supply examples
Overall Power
Consumption
P<2200W
2200W≤P<4400W
4400W≤P<6600W
......
30800W≤P<33000
W

Issue 01 (2018-05-03)
Name Location
PM A1
PEM B1
PM B1
N+1(-48 V DC)
A DC PM has output power of 2200 W. Use the N+1 PM backup mechanism as an
example. N+1 PMs are configured for power supply, with N being the number of PMs
required for the power consumption of the entire device. The value of N x 2200 W must
be greater than the overall power consumption of the entire device. Table 1-76 shows the
details.
If PMs are not fully configured, power cables are routed only for the PEM interfaces whose
corresponding PMs are installed. To facilitate the deployment of new power cables during capacity
expansion of PMs, you are advised to configure the PMs from the top down and leave a filler panel in
the position where no PM is not installed.
PM Configuration
1,2
1,2,3
1,2,3,4
......
1,2,3,4,5,6,7,8,9,10,
11,12,13,14,15,16
N+N(AC/HVDC)
A2 A3 A4
B2 B3 B4
B2 B3 B4
PM Cabling
A1,B1,A2,B2
A1,B1,A2,B2,A3,B3 2+1
A1,B1,A2,B2,A3,B3
,A4,B4
......
A1,B1,A2,B2,A3,B3
......A16,B16
1 Hardware Description
A5 A6 A7
B5 B6 B7
B5 B6 B7
N+1 Backup
1+1
3+1
......
15+1
A8
B8
B8
155