Xerox 4520 User Manual page 181

Figure 7.2 Control Panel messages (continued)
Message
Config. Sheet
Printing...
Disk Failure
Disk Format Bad
Disk Not In Use
Disk Read Error
Disk Write Error
Ethernet Fail
Fan Failure
Service Required
D i s p l a y e d C o n t r o l P a n e l M e s s a g e s
The Configuration Sheet is printing.
See Config. Sheet, page 3-64.
ACTION: None
A general failure of the hard disk has occurred.
Under this message, the following message is displayed:
Press *
ACTION: Press Enter
Disk Not In Use
Printing resumes without use of the hard disk.
The hard disk high level format (FAT tables) cannot be understood. This is NOT
because a new disk has been installed.
ACTION: This message flashes alternately with the two-line message:
Press to init
Press to Abort
A failure of the hard disk has occurred and been acknowledged. Printing resumes
without use of the hard disk.
ACTION: Check disk ribbon cable connections. If the problem remains, contact
your dealer or Xerox / Rank Xerox.
Printer cannot read data from the hard disk.
ACTION: Try powering OFF [0] then ON [1] again. Check disk ribbon cable
connections. If the problem remains, contact your dealer or Xerox / Rank Xerox.
Printer cannot write data to the hard disk.
ACTION: Press Enter
the write operation at another location on the disk. Check disk ribbon cable
connections. If the problem remains, contact your dealer or Xerox / Rank Xerox.
The Ethernet card (XNIC-E'NET) has failed and cannot be used.
ACTION: Press Enter
card were not installed. This error is not subject to Auto Continue (page 3-61).
Print a Configuration Sheet. If the sheet does not show Ethernet as present,
contact your dealer or Xerox / Rank Xerox.
A fan in the printer has failed; printing cannot resume.
ACTION: Contact your dealer or Xerox / Rank Xerox.
C h a p t e r 7 : T r o u b l e s h o o t i n g
Description/Action
The printer displays the following message:
The printer will mark the disk sector as bad and retry
to allow the printer to continue as if the Ethernet
7-7