Replacing A Biu Or Rectifier - Avaya MCC1 Maintenance Procedures

Replacing a BIU or rectifier

Figure 106: Removing the G600 fan assembly
3 Plug in the new fan assembly. The power for the fan automatically connects when the fan
assembly is plugged in.
4 Tighten every thumb screw on the fan assembly.
Replacing a BIU or rectifier
To remove a battery interface unit (BIU) or rectifier, first attach a grounding strap from the cabinet to
your bare wrist, and then perform the following steps:
1 Unlock the latch pin.
2 Pull down on the locking lever until the BIU or rectifier moves forward and disconnects from its
socket.
3 Pull the BIU or rectifier out just enough to break contact with the backplane connector. Use
steady, even force to avoid disturbing the backplane.
4 Carefully slide the BIU or rectifier out of slot.
To install a BIU or rectifier, first attach a grounding strap from the cabinet to your bare wrist, and then
perform the following steps:
1 Insert the back edge of the BIU or rectifier, making sure that it is horizontally aligned. Slide the
unit into the slot until it engages the backplane. Use extreme care in seating the backplane
connectors.
2 Lift the locking lever until the latch pin engages.
3 Verify that the unit is seated correctly by observing the operation of the LEDs.
354
fndpremv LJK 102600
Maintenance Procedures
December 2003