Avaya MCC1 Maintenance Procedures page 283

Shutdown AUDIX
1 Connect the laptop to the S8100.
2 Click Start > Run.
3 Type telnet name in the dialog box.
4 In the Enter you login name dialog box, type lucent1, lucent2, or lucent3, and click OK.
5 In the Enter password dialog box, type the appropriate password for the login used, and click
OK.
A LAC prompt displays (LAC>).
6 Type bash
The bash window displays a prompt such as name-lucent1>.
7 From the bash window, type shutdown audix
NOTE:
You might see an error message stating that a "clean shutdown not possible. Forced
termination of process" This means that there was probably someone retrieving INTUITY
messages when you shutdown AUDIX. the shutdown will proceed normally, anyway.
8 Wait for the bash prompt.
9 Type d1stat to make sure INTUITY AUDIX is DOWN.
Audix and Audixnet should show DOWN.
10 Type exit to leave the bash window.
A LAC prompt displays (LAC>).
Save translations
1 Type definity
You automatically login to name Definity.
2 Select terminal type NTT.
3 From the command line, type save translations
4 After saving translations successfully, type logoff to log off the server.
5 Close the telnet window.
Backup the S8100
For information about how to start a web browser, see the procedure, "Via a Web Browser Session" in
Chapter 2, "Connectivity and Access" in Installation and Upgrades for the Avaya S8100 Media Server
with the Avaya G600 and CMC1 Media Gateways, 555-233-146.
1 Login to S8100 using Internet Explorer browser.
The URL is: http://hostname
Note: hostname is the name of the S8100 switch.
2 Click on the Administer System link.
3 Login, using lucent1, lucent2, or lucent3, with your current password assignment.
Maintenance Procedures
December 2003
Component replacement
S8100 component maintenance
283