Avaya MCC1 Maintenance Procedures page 310

5 Unplug the external power supply connection (Note 2 in
connectors,
!
6 Disconnect the modem from the RS-232 port on the RSA.
7 Disconnect and label the LAN connection (if used) from the Ethernet port on the RSA.
8 Pull the server forward so that the server rails expand and the retaining clips on the rails click into
place.
Removing the cover of the Media Server
Complete the following steps to remove the cover of the Media Server:
1 Unscrew the two captive screws on the back of the media server, as shown in
screws,
Figure 91: Captive screws
Figure notes
1 Captive screws
2 Slide the server cover back from the front panel until the cover's tabs are released from the top
slot of the front panel.
3 Lift the cover straight up and move it away from the server.
310
on page 304) from the RSA.
DANGER:
Ensure that all power is removed from the media server and the RSA.
on page 310.
d is
c
Figure 85, RSA faceplate and
Figure 91, Captive
1
h3mscaps LAO 070103
Maintenance Procedures
December 2003