Avaya MCC1 Maintenance Procedures page 352

S8700 component maintenance
2 Partially pull out the hard drive bracket
352) so that you can disconnect the cables. Note the position of the ribbon cable within the chassis
so you can return it to exactly the same position later.
3 Unplug the 4-wire power cable from the back of the hard drive
and hard drive,
4 Unplug the ribbon cable from the back of the hard drive
drive, on page 352). Note that the red stripe on the ribbon cable is on the side closest to the power
cable.
5 Pull the hard drive bracket from the media server, and place the hard drive and bracket assembly
on your antistatic mat.
6 Unscrew the four screws holding the hard drive in the hard-drive bracket
bracket and hard drive,
Figure 105: Hard drive bracket and hard drive
1
1
Figure notes
1 Faceplate screw
2 1/8 to 1/4 inch gap
3 Hard drive
4 Bracket screws
Install new hard drive
1 Insert the new hard drive into the hard drive bracket so that the end of the hard drive is 1/8 to 1/4
inches from the faceplate of the bracket
352).
2 Reinsert the four bracket screws to attach the hard drive to the bracket
bracket and hard drive,
352
on page 352).
on page 352). Remove the hard drive from the bracket.
4
2
4
5
6
7
on page 352).
(Figure 105, Hard drive bracket and hard drive,
(Figure 105, Hard drive bracket
(Figure 105, Hard drive bracket and hard
4
3
I
4
Power cable
Ribbon cable
Position of red stripe
(Figure 105, Hard drive bracket and hard drive,
on page
(Figure 105, Hard drive
5
P4
7
6
drdsdrtp LAO041503
on page
(Figure 105, Hard drive
Maintenance Procedures
December 2003