Table of Contents
Advertisement
5.1
Network basic parameters
[Pr. NPA01_IP address setting]
Initial value
0
For the setting of IP addresses which are necessary for communication, select whether to use the rotary switches or to use
network parameters to obtain the IP addresses.
To enable this network parameter, cycle the power or reset the software after setting.
This network parameter cannot be rewritten via the parameter automatic setting.
Setting value
0: The rotary switch is
used.
1: Network parameters
are used.
The initial value of the IP address is as follows.
Item
IP address
Subnet mask
5 NETWORK PARAMETER DETAILS
148
5.1 Network basic parameters
Setting range
Refer to the text
Rotary switches (SW1/SW2) IP address
00h
01h to FEh
FFh
Size
4 bytes
1st octet
The 1st octet of the setting value in [Pr. NPA02] is used.
2nd octet
The 2nd octet of the setting value in [Pr. NPA02] is used.
3rd octet
The 3rd octet of the setting value in [Pr. NPA02] is used.
4th octet
The 4th octet of the setting value in [Pr. NPA02] is used.
1st octet
The 1st octet of the setting value in [Pr. NPA02] is used.
2nd octet
The 2nd octet of the setting value in [Pr. NPA02] is used.
3rd octet
The 3rd octet of the setting value in [Pr. NPA02] is used.
4th octet
The setting value of the rotary switch (SW1/SW2) is used.
1st octet
Not used
2nd octet
3rd octet
4th octet
1st octet
The 1st octet of the setting value in [Pr. NPA02] is used.
2nd octet
The 2nd octet of the setting value in [Pr. NPA02] is used.
3rd octet
The 3rd octet of the setting value in [Pr. NPA02] is used.
4th octet
The 4th octet of the setting value in [Pr. NPA02] is used.
Initial value
192.168.3.1
255.255.255.0
Ver.
A4
Advertisement
Table of Contents
