[Pr. Pt68_Function Selection T-11 (**Top11)] - Mitsubishi Electric Melservo-Jet MR-JET-G User Manual

[Pr. PT68_Function selection T-11 (**TOP11)]

Initial value
00000002h
[Pr. PT68.0_Quick stop method selection]
Initial value
2h
Select the quick stop method.
2: Servo-off after Quick stop
This function corresponds to [Quick stop option code (Obj. 605Ah)].
When the object is mapped to the cyclic communication, do not write values with engineering tools because the controller
overwrites the servo parameter values written with engineering tools.
[Pr. PT68.2_Temporary stop method selection]
Initial value
0h
Select a temporary stop method.
0: Automatic selection (deceleration to a stop method)
1: Deceleration to a stop method
This function corresponds to [Halt option code (Obj. 605Dh)].
When the object is mapped to the cyclic communication, do not write values with engineering tools because the controller
overwrites the servo parameter values written with engineering tools.
1 SERVO PARAMETER DETAILS
110
1.9 Positioning control setting servo parameters group ([Pr. PT_ _])
Setting range
Refer to the relevant detail No.
Setting range
Refer to the text
Setting range
Refer to the text
Ver.
Refer to the relevant detail No.
Ver.
A4
Ver.
A4