[Pr. Pd08_Output Device Selection 2 (*Do2)]; [Pr. Pd09_Output Device Selection 3 (*Do3)] - Mitsubishi Electric Melservo-Jet MR-JET-G User Manual

[Pr. PD08_Output device selection 2 (*DO2)]

Initial value
00000004h
Select the device to be assigned to the output signal of CN3 connector. The connector pin numbers to be assigned are as
follows.
Model
MR-JET-_G
[Pr. PD08.0-1_Device selection]
Initial value
04h
Refer to the following for setting values.
Page 70 [Pr. PD07_Output device selection 1 (*DO1)]

[Pr. PD09_Output device selection 3 (*DO3)]

Initial value
00000003h
Select the device to be assigned to the output signal of CN3 connector. The connector pin numbers to be assigned are as
follows.
Model
MR-JET-_G
[Pr. PD09.0-1_Device selection]
Initial value
03h
Refer to the following for setting values.
Page 70 [Pr. PD07_Output device selection 1 (*DO1)]
Setting range
Refer to the relevant detail No.
Axis Connector pin No.

CN3-9
Setting range
Refer to the text
Setting range
Refer to the relevant detail No.
Axis Connector pin No.

CN3-15
Setting range
Refer to the text
Ver.
Refer to the relevant detail No.
Initially assigned device
INP
Ver.
A4
Ver.
Refer to the relevant detail No.
Initially assigned device
ALM
Ver.
A4
1 SERVO PARAMETER DETAILS
1.5 I/O setting servo parameters group ([Pr. PD_ _ ])
1
71