Omron SYSMAC C200H-TC Operation Manual page 47

Memory Allocation
I/O I/O Word Word
Input n+3
n+4
n+5
n+6
n+7
n+8
n+9
4-1-2 Memory Contents
SW2-1 Set for Fixed Memory Allocations
I/O
Output
38
Downloaded from Elcodis.com electronic components distributor
15 14 13 12
Loop 1 PV (see note)
Loop 2 PV (see note)
Read data
0
Loop 1 executed bank
number b
Loop 1 status data
0 Sen- CT 0
sor over-
error flow
Loop 2 status data
0 Sen- CT 0
sor over-
error flow
Note For four-digit BCD and platinum resistance thermometer data, the least
significant digit = 0.1, and the most significant digit (F) = minus (–). For example,
"1000" represents 100.0 C for a platinum resistance thermometer.
Address Data item
Word Bit
n 15 to 00 Loop 1 SP
n+1 15 to 00 Loop 2 SP
n+2 15 to 12 Loop 1
executed
bank
number
11 to 08 Loop 2
executed
bank
number
07 ---
06 Loop 1
STOP
05 ---
04 Loop 2
STOP
03 to 00 ---
Bit
11 10 09 08 07
Write 0 0 Write 0
error com-
plete
Loop 2 executed bank 0
number b
0 0 0 STOP 0
0 0 0 STOP 0
(C200HX/HG/HE, C200HS, C200H: n=100 + 10 x Unit number)
Sets the Loop 1 and Loop 2 SP (set point) as 4-digit BCD data.
For platinum resistance thermometer data, the least significant
digit is 0.1. Set the most significant digit to F for minus (–). digit is 0 1 Set the most significant digit to F for minus (–)
Note These specified values apply to the bank number set with Wd
(n+2) and can only be changed in RAM. (Refer page 44 )
Sets the bank number executed for Loop 1 and Loop 2 as 1-digit
BCD data. Set executed bank numbers from 1 to 8. If the value is
set out of this range, the bank number reverts to the previous
value (default value = 1). a ue (de au a ue
Not used. Set to 0.
Bit set to 0 during temperature control of Loop 1 and set to 1
when the control stop is executed. This bit will not be available
under the program mode with SW203-5 set to ON (same as the
control stop).
Not used. Set to 0.
Bit set to 0 during temperature control of Loop 2 and set to 1
when the control stop is executed. This bit will not be available
under the program mode with SW203-5 set to ON (same as the
control stop).
Not used. Set each bit to 0.
Section 4-1
06 05 04 03 02
0 0
0 0
0 0 Con- AT HB
trol
out-
put
0 0 Con- AT HB
trol
out-
put
(CS1: n=2000+10 x Unit number)
Data contents
)
01 00
0 Read
com-
plete
SW data
2-2 2-1
AL1 AL2
AL1 AL2