Table of Contents
Advertisement
Nomenclature and Features
3-3-2 Features
Data Display
Operation Indicators
Display Patterns
Executed bank num-
ber or displayed
bank number
Downloaded from
Elcodis.com
electronic components distributor
Name
PV (Process
Displays the PV or the parameter symbol selected with the Level
Value)
or Display Key (Refer to next page).
SV (Set Value)
Displays the SV or setting/monitored data corresponding to the
parameter symbol selected with the Level, Display or Loop Keys
and indicated in the PV display. Displays the SP when the PV is
indicated in the PV display.
BK (Bank
Displays the executed bank number. Displays the bank number of
Number)
the displayed data when temperature control is interrupted. (See
note)
Note Temperature control is interrupted when SW203-5 on the rear panel is set to ON
and also the CPU Unit is set to PROGRAM mode, or when the Stop Bit (word
n+2, bit 06 for loop 1 and bit 04 for loop 2) is ON.
Name
LOOP2
Indicates whether the displayed settings relate to Loop 1 or Loop
2. Press the Loop Key and hold down for approximately 2
seconds to switch between Loop 1 and Loop 2.
OUT (Output)
Turns ON when the output is ON for
transistor output or voltage output types.
AT
Blinks at approximately 1 second intervals
(Auto-tuning)
during auto-tuning.
HB (Heater
Turns ON to indicate a heater burnout
Burnout)
alarm.
ALM1 (Alarm)
Turns ON to indicate the temperature is in
the alarm range set with Alarm SV 1
(upper- and lower-limit alarm). Refer to the
following page.
Display Pattern 1
Process
value
Set point
Executed
bank number
or displayed
bank number
Indicator OFF: Loop 1
Indicator ON:
Loop 2
Function
Function
Indicator OFF: Loop 1
Indicator ON:
Loop 2
Display Pattern 2
Indicator OFF: Loop 1
Indicator ON:
Loop 2
Section 3-3
These indicators
relate to the
currently displayed
tl di
l
d
loop.
Parameter symbol
SV (Set value)
Monitored value
Execution status
25
Advertisement
Table of Contents
