Kermit Csv Upload; Installing Or Deleting An Uploaded Csv File - Avaya INDeX 30 Installation & Maintenance

Maintenance

Kermit CSV Upload

Installing or Deleting an Uploaded CSV File

Installation & Maintenance
INDeX 30
1. Copy the CSV file to the same directory as Kermit.
2. Connect the PC serial link to serial port 1 and log on from Kermit as normal.
3. Set the switch and PC to the fastest matching speed supported (see page 35).
4. From the Administration menu, select System, Installation, Data Installation.
5. Select Upload file and wait for the # N3 prompt.
6. Press Ctrl and ] simultaneously, then press C.
7. At the Kermit prompt, type SEND and press ↵.
a. The system requests "Local Source File". Enter the name of the CSV file to
be uploaded.
b. The system request "Remote Destination File". Enter DY.
8. The screen shows the progress of the database file transfer. The PC beeps on
transfer completion.
9. Enter FIN and wait a few seconds until the MS-Kermit> prompt appears.
– If the prompt does not appear, press ↵ several times until "Unable to tell
host that session has finished" appears.
10. Press C and then ↵ to reconnect to the system.
11. Press Esc to restart normal system programming.
Once a CSV file has been uploaded to a system by FTP or Kermit, it can be viewed
and then installed or deleted.
1. Log into the INDeX administration menus.
2. Select System, Installation and then Data Installation.
3. If the CSV file has successfully been uploaded then the line Upload file should
now show File loaded.
4. Use Data preview to view the uploaded file. Press ↵ to extend the preview.
5. To add the uploaded directory settings to the INDeX select Install/Update.
– To remove an uploaded file without installing it, use the Release upload
buffer command in the Maintenance menu.
CSV Directory Upload - Page 45
Maintenance - Page 45
38DHB0002UKDF- Issue 4 (07/2001)