Table of Contents
Advertisement
Page 38 - Database Download
Kermit Database Download
Page 38 - Maintenance
INDeX 30
For a database download you must connect to serial port 1 of the system. To
minimise the download time set both the system serial port and the PC to the
highest matching speed possible.
1. Connect the PC serial link to serial port 1 of the system and log on from Kermit
as normal.
2. Set the system and PC to the fastest matching port speed they support (See
page 35).
3. From the Administration menu, select Database Management.
4. Select Download and wait for the # N3 response to appear.
5. Press Ctrl and ] at the same time, then press C.
6. At the Kermit prompt, type GET and press ↵.
a. The system requests the "Remote Source File". Enter DB.
b. The system requests the "Local Destination File". Enter the name of the DOS
file name for the downloaded database.
7. The screen shows the progress of the database file transfer. The PC beeps on
completion of the transfer.
8. Enter FIN and wait a few seconds until the Kermit-MS> prompt appears.
9. Press C and then ↵ to reconnect to the system.
10. Press Esc to restart normal system programming.
11. The downloaded database file is located in the Kermit directory under the name
specified above.
Maintenance
Installation & Maintenance
38DHB0002UKDF- Issue 4 (07/2001)
Advertisement
Table of Contents
