Wall Mounting Terminals - Avaya INDeX 30 Installation & Maintenance

Terminal Installation

Wall Mounting Terminals

Additional Items :
– Two No. 8 Pan or Round head
screws.
– Two wallplugs.
– Drill and drill bit.
– Screwdriver.
Installation & Maintenance
INDeX 30
Mounting brackets exist which clip onto the base on INDeX terminals. These
brackets (two required per phone) can be used to either raise the desk position of
the terminal or for wall mounting. Before wall mounting a terminal, check that the
surface is flat, vertical and not subject to movement or vibration.
To wall mount an INDeX terminal :
1. Using the templates below, mark the position for the screw holes. Ensure that
adequate clearance above and below the terminal is allowed.
2. Drill the necessary holes and insert the wall plugs.
3. Insert the screws, leaving the heads approximately 3mm proud of the surface
(check by clipping a bracket over the screw head).
4. Attach the brackets to the terminal. Then slide the bracket key-slots over the
screw-heads.
5. Where fitted, reverse the position of the hook switch tab (located next to the
hook switch button on the terminal.
INDeX 2030/50/60 Terminals
(Not to scale)
Wall Mounting Terminals - Page 31
INDeX 2010 , INDeX 20AT Terminals
(Not to scale)
Terminal Installation - Page 31
38DHB0002UKDF- Issue 4 (07/2001)