Wall Mounting - Avaya INDeX 30 Installation & Maintenance

Installing a New System

Wall Mounting

Viewed from back
Installation & Maintenance
INDeX 30
This section covers the wall-mounting of an INDeX 30 cabinet. Ensure the section of
wall chosen is solid, vibration free and flat.
To wall mount a cabinet :
1. Check that you have sufficient clearance around the cabinet as shown below.
2. Mark two mounting bracket holes using the details below:
– On a horizontal line 65mm below the top of the cabinet, mark 2 holes at
120mm either side of the cabinet's vertical centre-line.
Vertical clearance
500mm Minimum
Top of cabinet
Horizontal
Wall Bracket
clearance
Fixing Screw Holes
50mm Min.
350mm
Vertical clearance
500mm Minimum
3. Drill and insert wallplugs suitable for 5mm woodscrews (25mm length minimum)
supporting a 10Kg load in each hole.
4. Screw the cabinet mounting bracket to the wall.
5. Remove the front cover from the cabinet and hang the cabinet from the
mounting bracket.
6. Use the cabinet as a template to mark the lower fixing hole (at the back left hand
corner of the cabinet).
7. Remove the cabinet and prepare the lower fixing hole. Replace the cabinet and
put a fixing screw through the hole at the back of the cabinet.
8. Replace the front cover.
Centre
Line
120mm 120mm
Wall Bracket
Fixing Screw Holes
Fixing Screw Hole
(Within Cabinet)
450mm
Wall Mounting - Page 11
65mm from top to
Centre Line for
Wall Bracket
Fixing Screw holes
Horizontal
clearance
50mm Min.
Installing a New System - Page 11
38DHB0002UKDF- Issue 4 (07/2001)