Table of Contents
Advertisement
Page 14 - Install Optional IVM Lite PCB
Install Optional IVM Lite PCB
Page 14 - Installing a New System
INDeX 30
Use the following procedure to install the optional IVM Lite daughter board.
Installing the IVM daughter board:
1. Ensure that the mains supply is switched off and, if fitted, the Back up Battery is
also switched off Remove the front cover from the cabinet.
With the front cover removed, hazardous voltages can exist on the PSU board.
Both the ac supply and the Back-up Battery can generate these voltages.
2. Before removing the IVM daughter board from it's protective wrapping, wear an
earth strap on your wrist and ensure that it is connected to the INDeX 30's
protected earth.
3. Locate and push the IVM Lite board on to the high density D-type (120 pin)
socket on the mother board as shown below. Secure onto the stand-off pillar
using the screw and washer provided.
Battery Back-up Kit
On/Off Switch
Protected Earth
Terminal
Power Supply Socket
4. Replace the front cover of the cabinet and secure with the two retaining screws.
5. Reconnect the ac mains supply and, if fitted, switch the Battery Back-up switch
to On.
6. The IVM Lite Voice Prompts must be down loaded on to the IVM Lite memory.
Use the instructions given in "INDeX 30 Software Upload" on page 45 with the
"Local Source File" and the "Remote Destination File" both set to mb.
7. Voice mail boxes must be allocated to terminals (see page 27).
To download the voice prompts and messages, see page 36.Full details of the
setting up and allocation procedures for IVM Lite are given in the INDeX 9.1
Programming Reference and Voice Manager Installation Manuals.
WARNING
Top of cabinet
CPU Mother
PSU
Board
D-type plug
IVM Lite
Installation & Maintenance
38DHB0002UKDF- Issue 4 (07/2001)
Installing a New System
Board
Securing
Screw
Advertisement
Table of Contents
