Option 11C Dti Maintenance Tools; Dti Commands - Nortel Meridian 1 Option 11C Manual

Page 74 of 126 DTI Maintenance

Option 11C DTI maintenance tools

DTI commands

LD 60 – DTI commands.
Command
DLBK L
RLBK L
DISI L
DISL L
553-3011-315 Standard 13.00
Table 23
NTAK10 Faceplate LEDS (Part 2 of 2)
Off
CC On (Red)
On (Green)
Flashing
(Green)
Off
The tables below provide DTI and clock controller maintenance commands.
You must disable the clock controller before unseating circuit cards,
otherwise the system will initialize and momentarily interrupt call
processing.
Below is a quick reference list of important 2.0 Mb DTI commands in LD 60.
Action
Disable "loopback mode" for 2.0 Mb DTI
Enable "loopback mode" for 2.0 Mb DTI
Disable 2.0 Mb DTI when idle
Force disable 2.0 Mb DTI
January 2002
NTAK10 2.0 Mb DTI is not in loop-back
mode
The clock controller is switched on and
disabled
The clock controller is switched on and is
either locked to a reference or is in free
run mode
The clock controller is switched on and
locking onto the primary reference
The clock controller is switched off
WARNING