Avaya G350 Installing And Upgrading page 36

Installing the Avaya G350 Media Gateway
!
CAUTION:
Separate ESD paths to the chassis ground connect to the media modules at the
CAUTION:
spring-loaded captive screws. Use a screwdriver to ensure the captive screws are
securely tightened to prevent damage to the equipment.
1. Remove the plate between slots V1 and V2, labelled "Remove before removing or
inserting S8300 module."
2. Remove the blank plate from slot V1.
3. Position the media module before the V1 bay opening and engage both sides of the
module in the interior guides.
4. Slide the S8300 module slowly into the chassis, maintaining an even pressure to assure
that the module does not become twisted or disengaged from the guides.
Figure 6: Inserting the S8300 media server module.
5. Apply firm pressure to engage the connectors.
The connector has different length pins. The long pins will engage first to provide
grounding. Medium length and short pins will provide power and signal.
6. Lock the S8300 Media Server module into the chassis by tightening the spring-loaded
captive screws on the front of the module.
7. Replace the plate labelled "Remove before removing or inserting S8300 module" between
slots V1 and V2, and tighten the screws on the front of the plate.
After you have inserted the S8300 Media Server module, if applicable, insert the rest of the
media modules. Make sure to insert each module in a permissible slot.
36 Installation and Upgrades for the Avaya G350 Media Gateway