Appendix D: Running The Gateway Installation Wizard (Giw); Running The Gateway Installation Wizard (Giw); Performing A Basic Configuration Of The G350 - Avaya G350 Installing And Upgrading

Appendix D: Running the Gateway
If you did not install an S8300 in the G350, you can use the Gateway Installation Wizard (GIW)
to perform the configurations required to complete the installation. GIW prompts you for all the
configurations required to complete the installation. If you have an EPW (see
Electronic Preinstallation Worksheet (EPW)
configuration parameters from the EPW to GIW as part of your GIW session.
GIW includes the option to enable a modem connected to the S8300. This appendix describes
how to run GIW, and how to connect and test a modem if you choose to enable the modem.

Running the Gateway Installation Wizard (GIW)

Running the GIW performs a basic configuration of the G350. The configuration can include:
Configuring the Primary Management Interface (PMI)
●
Setting SNMP communities and trap destinations
●
Upgrading firmware
●
Enabling a modem on the G350
●

Performing a basic configuration of the G350

1. Prepare a PC with a CD-ROM drive and a TFTP server on the network. This may be
needed for installing software and firmware upgrades.
Note:
When uploading firmware from the S8300 using TFTP, you may need to enable
Note:
TFTP service in the Set LAN Security parameters of your web server.
Note:
Firmware upgrades for the G350 and media modules can either be installed from
Note:
CD or downloaded from the Web. For information about downloading firmware
upgrades from the Web to the TFTP server, see
to a local TFTP server
Installation Wizard (GIW)
on page 100.
on page 22), you will be able to upload
Downloading G350 firmware files
Obtain the
Issue 4 February 2007 201