Copy/Sync Button; Reset Button - ZyXEL Communications NAS Series User Manual

Figure 2 Using the Power Button to Turn Off the NAS
Press
• To have the NAS go through its normal software shutdown process and turn itself off, press the
power button until you hear one beep (after about three seconds), then release it.
• To perform a hardware shutdown and have the NAS immediately turn itself off without going
through the normal shutdown process, press the power button until you hear a second beep
(after about five seconds), then release it.

1.6 COPY/SYNC Button

Use the COPY/SYNC button on the front panel to copy or synchronize files between a connected
USB or SD device and the NAS. See
configure the copy/sync settings.

1.7 RESET Button

Use the RESET button on the rear panel to restore the NAS's default settings.
Figure 3 The RESET Button
Press
• Press the RESET button until you hear one beep (after about two seconds), then release it. You
will hear one more beep after you release the button.
This resets the NAS's IP address and password to the default values.
• Press the RESET button until you hear two beeps. After the second beep, continue pressing the
button for five more seconds, then release it. You will hear three quick beeps after you release
the button.
This resets the NAS to the factory default configuration. All settings you have configured on the
NAS, including IP address, password, user accounts, groups, and so on will be reset to the
factory defaults.
The reset process does NOT affect the volume settings, nor data stored on the NAS.
Chapter 1 Getting to Know Your NAS
1 Beep
3 seconds
Release for
software
shutdown
1 Beep
Release to Reset
IP Address
Password
Cloud Storage User's Guide
2 Beeps
2 more seconds
Release for
hardware
shutdown
Section 17.10 on page 232
2 Beeps
17
for more details on how to
5 more seconds
Release to
Clear All Settings