Copy/Sync Button; Reset Button - ZyXEL Communications NAS326 User Manual

Power On
• Press the power button for one second to turn on the NAS. When the system is on and ready, you will
hear one beep.
Power Off
Figure 2 Using the Power Button to Turn Off the NAS
Press
• To have the NAS go through its normal software shutdown process and turn itself off, press the power
button until you hear one beep (after about three seconds), then release it.
• To perform a hardware shutdown and have the NAS immediately turn itself off without going through
the normal shutdown process, press the power button until you hear a second beep (after about five
seconds), then release it.

1.6 COPY/SYNC Button

Use the COPY/SYNC button on the front panel to copy or synchronize files between a connected USB or
SD device and the NAS. See
sync settings.

1.7 RESET Button

Use the RESET button on the rear panel to restore the NAS's default settings.
Figure 3 The RESET Button
Press
• Press the RESET button until you hear one beep (after about two seconds), then release it. You will
hear one more beep after you release the button.
This resets the NAS's IP address and password to the default values.
Chapter 1 Get to Know Your NAS
1 Beep
2 more seconds
3 seconds
Release for
software
shutdown
Section 16.4 on page 282
1 Beep
Release to Reset
IP Address
Password
NAS Series User's Guide
2 Beeps
Release for
hardware
shutdown
for more details on how to configure the copy/
2 Beeps
5 more seconds
15
Release to
Clear All Settings