Backup: Step 1 - ZyXEL Communications NAS Series User Manual

Figure 200 Protect > Backup
The following table describes the labels in this screen.
Table 128 Protect > Backup
LABEL
Backup
Add Job
Edit Job
Delete Selected
Job(s)
Execute Job Now
Restore Archive
Abort Job
Activate Job
Inactivate Job
Status
Job Name
Job Description
Backup Info
Scheduler Info

27.3.1 Backup: Step 1

Use this screen to specify the job information and back up type.
Click Add Job in the Protect > Backup screen to open the following:
Chapter 27 Protect
DESCRIPTION
Click this to create and customize a backup job.
Select a backup job in the list and click this to make some changes to it.
Select a backup job in the list and click this to delete it.
Select a backup job in the list and click this to run the backup job immediately.
Select a backup job in the list and click this to restore the file(s) included in that backup
job to the NAS.
This applies to Archive backups only. Refer to
screens.
Select a backup job in the list and click this to stop the process if the backup job is
currently active.
Enable the selected backup job.
Disable the selected backup job.
This shows the current state of the backup job.
• Waiting means the backup job is not active but is scheduled to run at some time.
• Running indicates that the NAS is currently doing the backup job. When the backup
job is running, you can also see a progress bar.
This identifies the backup job.
This is a short description of the backup job.
This lists down the backup job details: type, source and target. Refer to
on page 322 and Section 27.3.2 on page
This shows the backup schedule, including the frequency, the time it was last run in
(and whether or not it succeeded), and when it is scheduled to run again. The times use
yyyy-mm-dd hh:mm:ss format.
Refer to Section 27.3.4 on page
Cloud Storage User's Guide
322
Section 27.3.8 on page 330
323.
326.
to see the
Section 27.3.1