Electrical Installation; Table 4-3: Contact Crimp Tooling - Garmin G5 Installation Manual

Portable Avionics Interface Connector
4.1.8
The portable interface connector (3P51) can be mounted to the instrument panel or a kick panel located in
the cockpit. The restrictions for mounting this connector are:
1. Do not mount connector to yoke
2. Maintain at least a 0.20" distance from the edge of the panel.
3. Cannot be mounted in a plastic interior panel, composite is acceptable
4. Connector must be electrically bonded to airframe, see section 4.5.
Connector can be mounted on a fabricated bracket made of 2024-T3 aluminum alloy sheet per AMS-QQ-
A-250/4 or clad 2024-T3 aluminum alloy sheet per AMS-QQ-A-250/5. Minimum sheet thickness of
0.032".
See section 5 for complete wiring interface.

4.2 Electrical Installation

Special Tools
4.2.1
Crimp tools and positioners are required to ensure consistent, reliable crimp contact connections for the
D-sub connectors. The following crimp tools are recommended:
Manufacturer
MIL-Spec
Daniels
Power Distribution
4.2.2
The circuit protection device for the G5 and GAD 29/29B must be a push-pull manually resettable
circuit breaker or identically rated circuit protection device approved by the aircraft type certificate. See
Section 3.2.1 for required circuit breaker part numbers. Use the following guidance for which electrical
bus the G5 needs to be connected (Note: some aircraft manufacturers may label the battery bus as
"essential bus" or "main bus"):
•
G5 needs to be connected to the battery bus when installed:
o As an Attitude Indicator (ADI), installed in either the turn coordinator or attitude
indicator position
•
G5 needs to be connected to the avionics bus when installed:
o As a HSI
o In the DG position
Garmin G5 Electronic Flight Instrument Part 23 AML STC Installation Manual

Table 4-3: Contact Crimp Tooling

Crimp Tool P/N Positioner P/N
M22520/2-01 M22520/2-08
AFM8 K13-1
Page 81
Insertion/Extraction Tool P/N
M81969/1-02
190-01112-10
Rev. 21