Garmin G5 Installation Manual page 176

GPS 175/GNC 355 Configuration
5.19.2
Config Page
Interfaced Equipment - ARINC 429
Interfaced Equipment – RS 232
GNX 375 Configuration
5.19.3
Config Page
Interfaces - ARINC 429
Interfaces – RS-232
Note 1: Set configuration values and units to match the values indicated in the appropriate AFM and
document settings in the space provided.
Note 2: If the aircraft has no AFM set the values as determined by the existing placards, instrument bugs
or instrument markings.
Note 3: Existing placards related to airspeed limitations must be retained.
Note 4: Setting can remain at default setting, not supported in this configuration.
Note 5: The "Selected Course" will display when only one navigator is interfaced to the G5.
Note 6: "Selected Course 1" and "Selected Course 2" will display when dual navigators are interfaced. If
GPS175/GNX375/GNC355 is navigator #1, "Selected Course 1" is set to "Enabled". If
GPS175/GNX375/GNC355 is navigator #2, set "Selected Course 2" to "Enabled".
Garmin G5 Electronic Flight Instrument Part 23 AML STC Installation Manual
Config Option
ARINC RX Port (x)
(x represents any available ARINC 429 Port)
ARINC TX Port 1
SDI
Port (x)
(x represents any available RS-232 Port)
Config Option
ARINC RX Port (x)
(x represents any available ARINC 429 Port)
ARINC TX Port 1
SDI
Port (x)
(x represents RS-232 Port 1 or 2)
This area intentionally blank
Page 176
Configuration Setting
Speed = Low
Format = GDU Format 1
Speed = Low
Format = GAMA Format 1
LNAV1 (If GPS is #1 navigator)
Or
LNAV2 (If GPS is #2 navigator)
MapMX (Format 1)
Configuration Setting
Speed = Low
Format = EFIS/Air Data
Speed = Low
Format = GAMA Format 1
LNAV1 (If GNX is #1 navigator)
Or
LNAV2 (If GNX is #2 navigator)
MapMX (Format 1)
190-01112-10
Rev. 21