Garmin G5 Installation Manual page 103

QQB575*34*375
QQB575*32*375
QQB575*30*375
QQB575*30*473
QQB575*36*500
QQB575*34*500
QQB575*32*500
QQB575*30*500
NOTE:
The following buildup instructions are only if the bonding strap being installed requires a #10
ring terminal for termination at a LRU backshell.
Create the bonding strap using the following instructions:
1. Cut an appropriate length of a metal braid listed in the table (maximum 10 inches)
2. Terminate both ends with the stated MS25036 terminal
3. Find a location on structure to create or re-use an existing ground stud that is size #10 for
connection to this bonding strap from the LRU backshell.
4. If creating a new ground stud, create a #10 ground stud in accordance with the instructions stated
in this section. Hole to be Ø0.201.
5. If using a #8 ring terminal for connection to the backshell, reference Figure 4-49 for hardware
buildup using ring terminal bonding strap part numbers listed in Table 4-9.
6. If using a #10 ring terminal for connection to the backshell, use the following method to connect
the #10 terminal to the LRU backshell, create the following hardware buildup as shown below in
Figure 4-62.
7. Torque backshell hardware buildup to 11-17 in-lb.
Garmin G5 Electronic Flight Instrument Part 23 AML STC Installation Manual
MS25036-112 (#10) or
MS25036-156 (#8)
MS25036-112 (#10) or
MS25036-156 (#8)
MS25036-115
MS25036-115
MS25036-115
MS25036-115
MS25036-115
MS25036-119
Page 103
AA59569*34*0375
AA59569*32*0375
AA59569*30*0375
AA59569*36*0500
AA59569*34*0500
AA59569*32*0500
AA59569*32*0500
MS25036-112 (#10) or
MS25036-156 (#8)
MS25036-112 (#10) or
MS25036-156 (#8)
MS25036-115
MS25036-115
MS25036-115
MS25036-115
MS25036-119
190-01112-10
Rev. 21