Garmin G5 Installation Manual page 143

GNS 480 Configuration
5.11.5
Config Page
GND Maint Serial Setup
GND Maint ARINC 429 Setup
GND Maint Resolver Interface Setup
GND Maint Miscellaneous Setup
Note 1: Set configuration values and units to match the values indicated in the appropriate AFM and
document settings in the space provided.
Note 2: If the aircraft has no AFM set the values as determined by the existing placards, instrument bugs
or instrument markings.
Note 3: Existing placards related to airspeed limitations must be retained.
Note 4: Setting can remain at default setting, not supported in this configuration.
Note 5: The "Selected Course" will display when only one navigator is interfaced to the G5.
Note 6: "Selected Course 1" and "Selected Course 2" will display when dual navigators are interfaced. If
GTN/GNS is navigator #1, "Selected Course 1" is set to "Enabled". If GTN/GNS is navigator #2,
set "Selected Course 2" to "Enabled".
Garmin G5 Electronic Flight Instrument Part 23 AML STC Installation Manual
Config Option
CH (x)
(x represents any available Serial Channel)
CH In (x)
(x represents any available ARINC 429 Port)
CH Out (x)
(x represents any available ARINC 429 Port)
CH Out (x)
(x represents any available ARINC 429 Port)
Resolver
CDI Select
This area intentionally blank
Page 143
Configuration Setting
Output = MapMX
SEL = EFIS
SPEED = Low
SDI =
SYS1 (If GNS is #1 navigator)
Or
SYS2 (If GNS is #2 navigator)
SEL = GAMA 429
SPEED = Low
SDI =
SYS1 (If GNS is #1 navigator)
Or
SYS2 (If GNS is #2 navigator)
SEL = VOR / ILS
SPEED = Low
SDI =
SYS1 (If GNS is #1 navigator)
Or
SYS2 (If GNS is #2 navigator)
Not Installed
Use
190-01112-10
Rev. 21