Interlogix FlexZone Series Product Manual page 92

Chapter 4: Maintenance
Figure 76: Updating the firmware
FIRST - FPGA update
Update the FPGA firmware first:
1. Start the UCM and make a connection to the FlexZone processor.
2. Select the Application button.
3. Select the FPGA button.
4. Select the Browse button.
5. Navigate to the location of the XDU file.
6. Select and open the FlexZoneFPGA_x.xx.XDU file (x.xx = firmware version).
After the FPGA firmware update, the processor's two CPUs will be unable
Note:
to communicate with each other. As a result, a boot fail or processor offline error
may be reported. Ignore this error and proceed with the update.
Once the FPGA firmware is updated, update the MSP firmware:
1. Select the Application button.
2. Select the MSP button.
86
select the FPGA button
select the
Browse button
select the Application button
SECOND - MSP update
select the MSP button
FlexZone™ Product Guide
Select the Current
Active radio button
then select the
Browse button
navigate to the .XDU file
select and open the .XDU file
(FPGA or MSP)