Interlogix FlexZone Series Product Manual page 31

Note: Galvanized fencing occasionally has rough patches from the galvanizing
process. Avoid attaching the sensor cable at locations where rough galvanizing
can potentially damage the cable.
Installing cable ties
Using UV resistant polypropylene cable ties, secure the cable to the fence fabric
at the midpoint of the chain-link. Install the cable ties by hand, tightening them
enough to hold the cable securely against the fence.
Figure 20: Securing cable to chain-link fence
Attach the cable to the fence fabric
in the middle of a fence wire.
Bend radius
•
The minimum bend radius for FlexZone sensor cable is 10 cm.
Figure 21: Smallest allowable bend radius
At fence posts
Secure the cable at both sides of each fence post so the cable is in contact with
the post. The cable should have enough slack so that it is not stressed, but be
tight enough so that it cannot easily move.
FlexZone™ Product Guide
DO NOT attach the cable to the fence
fabric at the junction of 2 fence wires.
20 cm
(8 in.)
FlexZone sensor cable
Use 2 steel cable ties on each fence
panel in addition to the polyp opylene
ties for added security
steel cable tie
10 cm
(4 in.)
Chapter 2: Installation
r
polyp opylene r
cable tie
15 cm
(6 in.)
armored sensor cable
25
30 cm
(1 ft.)