Silver Network Wiring Connections - Interlogix FlexZone Series Product Manual

Figure 54: FlexZone processor wiring diagram
T4
power
self-test/auxiliary
input
AUX 1
POWER
-
+ -
T4 power output for
T7
T4
processors receiving
power over sensor
cables
- DC GND
+ 12 to 48 VDC
auxiliary/self-test inputs
-
AUX input 1
+
-
AUX input 2
+
relay 1 NC
relay 1 COM
relay 1 NO
relay 2 NC
relay 2 COM
relay 2 NO

Silver Network wiring connections

Note: A network interface card is required to enable Silver Network
communications between a FlexZone processor and the Silver Network
manager.
Note: For groups of FlexZone processors that communicate over the sensor
cables, only the processor that is connected directly to the Silver Network
requires an NIC.
Silver Network specifications
•
Data rate - fixed 57.6 k bps
•
Maximum 60 devices spread over up to 4 independent network loops
•
Two communication Channels (Side A, Side B)
•
Response time - 1 second, or less from alarm source to Network Manager
(per loop)
•
Network termination - not required
•
Transmission media/maximum separation distances between processors:
•
EIA-422 copper wire - 1.2 km (0.75 mi.) - 2 pairs per Channel
•
Multi-mode fiber optic cable (820 nm) - 2.2 km (1.4 mi.) - 2 fibers per
Channel - optical power budget 8 dB
FlexZone™ Product Guide
T7
relay outputs
inputs
AUX 2 RELAY 1 RELAY 2
NC COM NO NC COM NO
+ - +
T8
T8
A-Side
sensor cable
RELAY 3 RELAY 4 A-SIDE
NC COM NO NC COM NO
- -
+
T9
Chapter 2: Installation
T9
B-Side
B-SIDE
- -
+
B SIDE sensor cable
- shield
+ center conductor
- shield
A SIDE sensor cable
- shield
+ center conductor
- shield
relay 4 NO
relay 4 COM
relay 4 NC
relay 3 NO
relay 3 COM
relay 3 NC
47