Interlogix FlexZone Series Product Manual page 54

Chapter 2: Installation
•
Single-mode fiber optic cable (1310 nm) - 10 km (6.2 mi.) - 2 fibers per
Channel - optical power budget 8 dB
•
Ethernet - Category 5 cable, 100 m between PoE switch and processor
location
Note: Use low capacitance shielded twisted pair data cable for EIA-422,
62.5/125 multi-mode fiber optic cable, 9/125 single-mode fiber optic cable, and
Category 5 Ethernet cable. The maximum separation distances require high
quality transmission media and sound installation practices.
Caution: Both the FlexZone processor and the network interface cards contain
static sensitive components. Follow proper ESD handling procedures when
handling the cards.
Ensure the expansion header on the NIC is properly lined up and fully seated in
T2 on the processor.
Figure 55: Silver Network EIA-422 wiring connections
48
expansion header T1 (on solder side)
(plugs into T2 on processor)
mounting hardware (X 2)
A-side comms
B-side comms
Use single point grounding (connect one
end of shield, trim the other end and
leave it disconnected)
FlexZone™ Product Guide