Audio "Listen-In" Function - Interlogix FlexZone Series Product Manual

3. Select the Input/Aux checkbox to verify the auxiliary power output function, if
this processor will supply power to an auxiliary device via T4.
Note: The test functions are temporary settings and the processor will revert to
the Side A, Side B and Aux configuration settings when reset.
Once the functions are tested and verified on the UCM Status tab:
1. For power distribution via the A Side cable, on the Side A Cfig tab, select
Power Output and Cable pair/loop supervision.
2. For power distribution via the B Side cable, on the Side B Cfig tab, select
Power Output and Cable pair/loop supervision.
3. If this processor will provide power to an auxiliary device via T4, select the
Aux Power Output check-box on the Aux Config tab.
4. Save and download the configuration changes to the processor.

Audio "listen-in" function

The Audio listen-in function of the FlexZone processor provides a digital audio
representation of the signals received from the FlexZone sensor zones.
Using the Audio listen-in function via the UCM
The UCM enables the Audio listen-in function through a local USB connection or
remotely via the Network Manager. With a UCM connection you can listen to one
zone, or one sensor cable, or both sensor cables through the computer's audio
device. To use, or test, FlexZone's Audio listenin function via the UCM make a
connection between the UCM and the FlexZone processor.
1. On the Status tab in the Audio field specify what will be monitored (Zone,
Cable A, Cable B, Cable A & B).
2. Select the Speaker button to enable the Audio listen-in function.
3. Set the Squelch to prevent low level background noise from producing an
audio output.
4. Set the Limit to cut off high level signals (the high level signals will have
already produced an audio output upon exceeding the Squelch setting).
5. If Zone is selected for monitoring, use the Zone spin control to specify the
Zone number.
FlexZone™ Product Guide
Chapter 3: Calibration and setup
65