Installing The Flexzone Processor - Interlogix FlexZone Series Product Manual

Chapter 2: Installation
Figure 47: Gate disconnect assembly
cable tie
gear clamp
male disconnect
Installation instructions
1. Place the male cap stay wire over the open end of the non-detecting cable on
the male connector. Put the cap in place on the connector during installation.
2. Wrap a gear clamp (customer supplied) around the fixed post on the opening
side of the fence on which the gate disconnect will be mounted.
3. Before tightening the clamp, position the L-bracket against the post under the
clamp.
4. Tighten the clamp until the assembly is firmly attached to the post.
5. Dress the non-detecting cables to the splice kits with cable ties.
6. Follow the directions for a standard splice.
7. Attach the rubber cover over the disconnect assembly.
Note: When caps are not in use, they fit into one another for protection and
storage. Cap the connectors when the gate will be open for extended periods.

Installing the FlexZone processor

Do not remove the processor circuit card when installing the enclosure. The
processor is shipped with two gear clamps that are used for securing the
enclosure to a post. The hardware required to mount the enclosure on another
type of surface is customer supplied. Figure 50 on page 43 shows a fence
40
female cap
female disconnect
male cap
cable tie
splice kit (X 2)
protective rubber cover
disconnect
assembly
bracket
gear clamp
FlexZone™ Product Guide