Gate Disconnect Assembly - Interlogix FlexZone Series Product Manual

2. Make a service loop that reaches the gate without binding the cable when the
gate is fully opened in either direction.
3. Run the sensor cable around the perimeter of the gate panel in a diamond
pattern, app. 30 cm in from the edges. (For a double panel swinging gate
install the sensor cable on both gate panels.)
4. Pull the sensor cable through the buried conduit.
5. Seal the ends of the conduit.
6. Use cable ties to tightly secure any exposed bypass cable to the fence fabric.
7. Continue installing the sensor cable on the fence beyond the gate. (For a
double panel swinging gate install the sensor cable on the second gate panel
before continuing the cable run.)
Figure 46: Installing sensor cable on swinging gates
sensor cable

Gate disconnect assembly

Note: The gate disconnect assembly can be used only with sensor cables that
are not carrying power and data to other FlexZone processors. Otherwise, using
the gate disconnect will interrupt power and data to any processor further down
the line.
The gate disconnect assembly protects gates that are infrequently used. The
gate can be opened and closed by manually separating the connection (see
Figure 47 below). When the assembly is opened, a supervision alarm is
generated. When the assembly is closed the gate is protected.
FlexZone™ Product Guide
protected gates
bypass cable
Chapter 2: Installation
39