Output Relays - Interlogix FlexZone Series Product Manual

Chapter 3: Calibration and setup
R1 values (single resistor
supervision)
1.2 k
1.5 k
2.2 k
3.3 k
4.7 k
5.1 k
5.6 k
Input configuration procedure (Remote control mode)
1. Select the Aux Cfig tab on the UCM window.
2. From the Supervision drop down, select the desired supervision scheme for
the input.
3. Select the Resistor 1 value, if applicable.
4. Select the Resistor 2 value, if applicable.
5. Set the Noise Tolerance, if required.
6. Set the Line Drop, if required.
7. Set the Filter Window.
8. Repeat this procedure if there is a second connected input.
9. Save the UCM configuration file and download the configuration changes to
the processor.

Output relays

Output relay setup (Local control mode)
Note: To assign relays to specific zones, see "Linking cable segments to relays
(local control mode)" on page 77.
In Local control mode, the four relays are setup via the Local Aux Control
Activation check boxes to report alarm conditions. The relays are then controlled
by the processor to activate on the user-specified conditions. The relays remain
active for an event's duration or for the selectable relay Active Time, whichever is
longer.
1. Use the Output selection arrows to select a relay.
2. Specify the Hold/Active Time parameter.
3. Specify the conditions from the Local Aux Control Activation field under which
this relay will activate.
4. Repeat this procedure for the other relays.
76
R1 values (double resistor
supervision)
5.1 k
5.6 k
R2 values (double resistor
supervision)
5.6 k
FlexZone™ Product Guide