4
Installation for 990 Micro GC
Connect the transfer line to the GC
5 Align the holes in the mounting bracket to the screws on the side of the GC. Slide the mounting
bracket and gasifier into place, then tighten the three Torx T-20 screws to secure the gasifier.
Connect the transfer line to the GC
Connect the gasifier transfer line to the 990 Micro GC inlet directly using a 5/16 inch wrench.
Figure 6.
Use the Micro GC interface (Web UI, Local UI, or OpenLab) to set proper regulator & transfer line
temperatures.
Agilent 8860, 8890, and 990 Micro GC Gasifier User Manual
Front view
Transfer line connected to the 990 Micro GC.
Top view
33