4
Installation for 990 Micro GC
Connect the power cord and USB cable
Connect the power cord and USB cable
1 Connect the gasifier USB cable to the side of the gasifier and to an open USB port on the
Micro GC.
2 Connect the power connector to the gasifier, and then plug the power cord into an appropriate
power source.
3 Plug in the GC power cord and turn on the GC.
Update the GC Firmware and driver
The Agilent gasifier requires the minimum firmware and driver revisions listed on
Download the latest firmware and driver revisions from the Agilent web site at
www.agilent.com/chem, or contact your local Agilent sales representative.
Failure to update the firmware and driver will result in failing to recognize the gasifier.
NOTE
Configuring the GC and Data System
Agilent OpenLab CDS, Agilent OpenLab ChemStation, Agilent OpenLab CDS EZChrom Elite data
systems contain information about the sampling equipment in use. When gasifier hardware
installation is complete, update the GC configuration. See your data system documentation for
details.
Figure 9.
1 Select the instrument from the Instruments menu
2 From the Agilent OpenLab CDS configuration window, check Use Gasifier
3 Click Apply configuration
4 Reboot the 990 micro GC
36
Figure 9
shows an example for updating Agilent OpenLab CDS configuration.
Agilent OpenLab CDS configuration (example).
Agilent 8860, 8890, and 990 Micro GC Gasifier User Manual
page
30.